515 Results (0 seconds)

Status: Awarded
Published Date: 01/05/2024
Closing Date: 22/03/2024
Value: neg.
208-BD-23 Broadland Country Park Professional Services - AWARD - Broadland District Council is procuring a professional services contract to oversee RIBA Stage 2 - RIBA Stage 6 work at Broadland Country Park, Norfolk. The services will oversee the development of a visitor kiosk facility, the extension and surfacing of the existing car parks and parks, and the extension of Disability Discrimination Act compliant paths. This contract will support the design/sustainability, mechanical/electrical engineering, planning/ecology, and other professional and design services as required. The Contract Start date is 1st May 2024 and is expected to run for around 18 months.

Status: Open
Published Date: 30/04/2024
Closing Date: Unknown
Value: £64,000,000
Construction Project Management and Conservation Professional Services Framework (CPMCPS) - A Framework Agreement to appoint a pool of service providers to provide a range of Project Management and Conservation Professional Services. The Project Management consultancy services shall only be available to the NE5 group of Universities in the North-East which consists of the Durham, Newcastle, Northumbria, Sunderland and Teeside Universities and their subsidiaries (some of which may be outside the North-East of England). Conservation consultancy services shall be available to all NEUPC Members throughout the UK.

Status: Open
Published Date: 23/04/2024
Closing Date: 29/04/2024
Value: neg.
Heat Decarbonisation Strategy, Desktop assessment and Building audit - The University of Cumbria is in the process of finalising an updated Carbon Management Plan (CMP), which will set out a carbon management plan, which will seek a 40% reduction in Scope 1 and 2 emissions by 2030, with an overall 77% reduction against the original 2007-08 baseline. We are looking to tender for support in developing a Heat Decarbonisation Strategy to support an application to the Phase 5 Low Carbon Skills Fund .

Status: Awarded
Published Date: 23/04/2024
Closing Date: 22/01/2024
Value: neg.
Provision of Consultant Services to produce a Gypsy & Traveller Accomodation Assessment. - AWARD - Waverley Borough Council is seeking to procure a consultant to prepare the Gypsy and Traveller Accommodation Assessment (GTAA) to inform the new Local Plan.

Status: Awarded
Published Date: 19/04/2024
Closing Date: 25/02/2024
Value: £103,000
Employers Agent - Alcester Site - The contract has been awarded. Providing contract administration, third party certification, quality control, compliance and delivery of a scheme of 66 new homes.

Status: Awarded
Published Date: 18/04/2024
Closing Date: 08/12/2023
Value: £30,750
Consultancy Services for the Management of the Gas Suppression Intrusive Surveys, Hydraulic Calculations, Thames Water & Insurance Requirements - Consultancy Services for the Management of the Gas Suppression Intrusive Surveys, Hydraulic Calculations, Thames Water & Insurance Requirements

Status: Open
Published Date: 28/03/2024
Closing Date: 19/04/2024
Value: neg.
Invitation to Tender for Turf Fen and Boardman's Mill - Norfolk County Council is seeking to award 2 contracts for conservation accredited professionals with expertise in working on historic buildings, particularly mills to support the tender of works exercise using the schedule of works already prepared. The conservation accredited professionals will run the project in collaboration with Norfolk County Council to completion for Lot 1 Turf Fen Mill and/or Lot 2 Boardman Mill. You may bid for 1 or both lots.

Status: Open
Published Date: 27/03/2024
Closing Date: 12/04/2024
Value: neg.
MMIC BMS and EMS Annual Maintenance and Validation - The BMS and EMS system currently runs on Siemens Desigo CC and the facility is on the course to being a fully GMP compliant facility. There are currently ten BMS panels on the site with several sensors and control points that feed into these panels from various cleanroom and plant equipment. Our EMS and BMS systems both use the same sensors for control and monitoring but operate slightly differently. Our EMS system is fully audit trailed and validated yearly to keep this in line with GMP requirements. The EMS monitors all data coming from our clean rooms which monitors the temperature, humidity, airflow, and differential pressure across all four cleanrooms, service corridors and auxiliary areas. On site we currently have the below equipment and system checks required to be covered under the service agreement o 4 cleanrooms all fitted with 2 control panels, 4 differential pressure probes along with a temperature and humidity sensor. Each it will need to be fully calibrated annually along with all calibration reports provided. o We currently have 11 air handlers in total, 5 of these feed into our cleanroom areas while the other 6 units feed into control offices and event areas. All units have 2 fan speed controllers, 7 pressure transmitters, 1 fresh air temperature sensor, 3 temperature humidity sensors and 2 velocity meters. All of which require to be calibrated annually along with calibration reports. o Differential pressure switches that will need to be inspected to ensure the electrical operation of the circuit is running as it should. o As well as this, the switch setting must be checked, and you must ensure that it responds to changes in pressure. o Air and water flow switches that will need to be inspected to ensure the electrical operation of the circuit is running as it should. The switch setting must be checked to ensure that it responds to change in flow. Actuators/Valves/Dampers/Water Meters- Check the operation of actuators across their full stroke and ensure correct positioning over the analogue output range. Ensure actuator limit switches operate correctly along with Check power fail action operates correctly by simulating mains failure. Check valves for leaks and repair where applicable and ensure minimum let-by in the closed position. Check that the valve and damper linkage are fitted securely. Check that damper blades and linkage operates operate correctly throughout their range, without undue stiffness. Advise relevant Building Services Engineer of any mechanical problems. o Control Checks - Check the stability of all plant visually along with System Operation Checks. Authorisation will be sought from a member of the CPI operational Engineering team prior to isolating any plant, and care will be taken that any checks do not unduly affect environmental conditions. The system will be set to its 'off' condition (where possible) and check correct response of all controlled equipment. Along with Simu...

Status: Closed
Published Date: 27/03/2024
Closing Date: Unknown
Value: neg.
PS-23-77 - Provision of Building Services Engineering Services for the AMIC & Moorfield Projects - The provision of Building Servcies Engineer Consultancy to contribute to the overall project design development, through the provision of the activities highlighted in Schedule of Services and Design Responsibility Matrix, for the Ayrshire Manufacturing Investment Corridor (AMIC) and Moorfield projects on behalf of East Ayrshire Council.

Status: Open
Published Date: 26/03/2024
Closing Date: 26/04/2024
Value: neg.
Design team to deliver the Oxford Covered Market masterplan including essential works - Consultant team for the design and delivery of the Covered Market essential works and masterplan proposals from RIBA Stages 2-7